DIY 3D BABY MEMORY FOOTPRINT GOLDEN KIT

TodStar

$29.99 $39.99

Feature:

  • Material:100% Biodegradable powder

  • Color: as shown

  • Net Of Model Powder: 100g

  • Net Of Clone Powder: 100g

  • Safety: Non-Toxic, Non-Allergenic, 100% Biodegradable.

  • Application: Reproduce the hand or foot of your child three dimensionally and with accurate details.

  • Advantage: Preserve every detail, capture tiny toenails, fingernails, dimples & footprints ,even if baby wiggles.

Dosage:

  • 0-1 years: One hand (50g) one foot (100g)

  • 1-2 years: One hand (100g) one foot (150g)

  • 2-3 years: One hand (100g) one foot (200g)

  • 3-5 years: One hand (200g) one foot (250g)

  • Adult: One hand (300g)

  • Couple hands: One hand (600g)

Ready to work:

  • 1. a one-time cup: thicker, bigger, transparent the best (if the baby does not put in, you can consider the cup of tea)

  • 2.30-35 degrees pure water or tap water (please do not use mineral water)

  • 3. chopsticks,Spoon

  • 4. Thermometer

  • 5. Stopwatch: mobile phones, computers are, you can watch the clock

Steps:

  • 1. Take clone powder 50 grams, add 1.2-1.5 times the volume of water mixed, rapid mixing, then cloning powder and water mixture into a purple paste liquid, stir it, about 1 minute or so purple gradually receded, immediately Baby's little hands or feet into the liquid, the baby's little hands or feet must be soaked in the liquid inside, do not stick to the walls of the cup, while ensuring that the baby's hand or feet do not move, about 2 and a half times the liquid will solidify, please Keep 4 minutes and then remove the baby's hand or feet, can be removed before and after the move, let the air go, slowly removed.

  • 2. Take the model powder 50 grams, add 1 / 3-1 / 2 of water, water do not put too much, as long as the powder and water mixture into a liquid, the more concentrated the better, even after mixing, slowly poured into the colloid , Down a little, Akira look, to avoid the gas plug in the inside.

  • 3.2-5 hours after the or hand can be used to slowly open the colloid, must be carefully poke, not anxious.
    (Note: the surface of the work of a little powder can be rinsed with water, placed in a ventilated place to dry, it is recommended to dry for more than 24 hours.)

  • 4. Color: like to paint what color to give their own works painted what color it

Package Include:

  • 1PC Net Of Model Powder

  • 1PC Net Of Clone Powder

  • 6PC Paint

  • 1PC Brush